Try These Tips If You Have Plumbing Issues

 

 

Do you know if your plumbing system is running good? Do you want to improve your plumbing skills? If you want to, you're reading the right article. The tips in this article are full of advice on how you can do your own plumbing efficiently.

 

 

Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.

 

Use the sounds you hear from your pipes to help you to determine what they problem is. Certain sounds mean the water pressure is too high. Other sounds can signify loose pipes or slight clogs from calcium or iron build up. Listening to your pipes can save you a lot of money hunting down the problem.

 

On very cold winter nights, allow your faucets to trickle slightly, especially if your pipes are located in a crawlspace. The running water prevents the pipes from freezing as quickly as they would otherwise. You can catch the water and use it for other household needs to prevent wasting it.

 

To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.

 

To avoid having your outdoor faucets freeze up in the winter, detach all hoses before the first freeze. Also, close the shutoff valve that leads to the outdoor faucets, then turn on the outdoor faucets to let any remaining water in the lines drain. Once temperatures warm up in the spring, you can reverse the process.

 

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

 

Do not forget to check the temperature of the water heater in your house, especially if you are planning to leave for an extended period of time. You should keep the temperature no higher than 120 degrees, which will help to reduce energy use and prevent your system from burning out.

 

If you have a lot of hair in your shower drain, be sure to get a stopper and put it in the drain. This will catch the hair from going down the drain, which can clog it. Just make sure that you remove hair that is already in the drain before using the stopper.

 

One of the ways that you can improve the functionality of your shower head is to clean the mineral deposits from the surface. Unscrew your shower head and soak it in vinegar overnight. In the morning, brush off the deposits with a toothbrush to help the flow of water for your showers.

 

If you have a crack in your toilet tank, you can sometimes fix this with an epoxy resin. However, it is very difficult to keep up with this type of maintenance, and the best bet may be contacting the supplier and ordering a new tank to be installed in your bathroom. Nevertheless, keeping some epoxy resin on hand for emergencies is a good idea.

 

Good plumbers do work far beyond unclogging drains. A more common job for a plumber is fixing broken water lines.

 

To keep the pipes in your kitchen in tip-top shape, avoid pouring fats or cooking oils down the drain. These liquid fats solidify in the pipes and create clogs. As an added protection, wipe congealed grease from pots to further avoid creating clogged drains. By following these tips, you can help avoid a plumbing disaster.

 

If you are thinking about becoming a plumber yourself, then you should first try to start out as an apprentice. If you can find a good mentor then you will learn a great deal more from watching and assisting him than you possibly could learn by working on projects alone.

 

Now that you have read all of the tips, you are probably excited to get to work, and do your own plumbing. Avoid damaging your pipes by not using harsh chemicals. If not, continue to research more tips and learn more about plumbing.